Maintenance
194 Xerox
®
VersaLink
®
B7025/B7030/B7035 Multifunction Printer
User Guide
7. To print the sample pages, touch Print Sample.
8. When printing is completed, touch Close.
9. On the sample pages, for Side 1, use a ruler to measure the distance of the printed image from th
e
top
, bottom, left, and right edges.
Note: For identification, a single dot is printed on Side 1, and two dots are printed on Side 2.
10. For
Side 2, measure the distance of the printed image from the top, bottom, left, and right edges.
11. If the image is centered, no adjustment is required. If not centered, adjust the paper registration.
For details, refer to Performing a Paper Registration Adjustment.
Performing a Paper Registration Adjustment
1. At the printer control panel, press the Home button.
2. Log in as administrator. For details, refer to the System Administrator Guide a
t
www.xerox.com/office/VLB70XXdocs.
3. Touch Device > Support > Image Position.
4. To adjust registration, select the source paper tray.
a. Touch Paper Supply.
b. Touch the desired tray.
5. Using the chart printed in Verifying Paper Registration, select the side for registration.
a. For adjusting Side 1, touch Adjusted Side, then touch Side 1.
b. For adjusting Side 2, touch Adjusted Side, then touch Side 2.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
