Regulatory Information
256 Xerox
®
VersaLink
®
B7025/B7030/B7035 Multifunction Printer
User Guide
Environmental Benefits of Duplex Printing
Most Xerox products have duplex printing, also known as 2-sided printing, capability. This enables you to
print on both sides of the paper automatically, and therefore helps to reduce the use of valuable
resources by reducing your paper consumption. The Lot 4 Imaging Equipment agreement requires that
on models greater than or equal to 40 ppm color or greater than or equal to 45 ppm monochrome the
duplex function has been auto enabled, during the setup and driver installation. Some Xerox models
below these speed bands may also be enabled with 2-sided printing settings defaulted on at the time of
install. Continuing to use the duplex function will reduce the environmental impact of your work.
However, should you require simplex/1-sided printing, you may change the print settings in the print
driver.
Paper Types
This product can be used to print on both recycled and virgin paper, approved to an environmental
stewardship scheme, which complies with EN12281 or a similar quality standard. Lighter weight paper
(60 g/m²), which contains less raw material and thus save resources per print, may be used in certain
applications. We encourage you to check if this is suitable for your printing needs.
ENERGY STAR
The ENERGY STAR program is a voluntary scheme to promote the
development and purchase of energy efficient models, which help to reduce
environmental impact. Details on the ENERGY
STAR program and models
qualified to ENERGY
STAR can be found at the following website:
www.energystar.gov/index.cfm?fuseaction=find_a_product.showProductGro
up&pgw_code=IEQ
The ENERGY
STAR and ENERGY STAR mark are registered United States
trademarks.
The ENERGY
STAR Imaging Equipment Program is a team effort between
United States, European Union, and Japanese governments and the office
equipment industry to promote energy-efficient copiers, printers, fax,
multifunction printers, personal computers, and monitors. Reducing product
energy consumption helps combat smog, acid rain, and long-term changes
to the climate by decreasing the emissions that result from generating
electricity.
Power Consumption and Activation Time
The amount of electricity that a device consumes depends on the way the device is used. This device is
designed and configured to enable you to reduce your electricity usage.
Power Saver modes are enabled on your device to reduce energy consumption. After the last print, the
device transitions to Ready mode. In this mode, the device can print again immediately. If the device is
not used for a specified period, the device transitions to Low Power mode, then to Sleep mode. In these
modes, to enable reduced-power consumption, only essential functions remain active. The device takes
longer to produce the first print after it exits the Power Saver modes than it takes to print in Ready
mode. This delay is the result of the system waking up and is typical of most imaging devices on the
market.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
