2
Tools (in Admin Mode)
The following summarizes the various options from the Tools button on the press Control
Panel that can be set or used while logged in as administrator.
Note
The actual procedures for performing the Full Width Array tasks are referenced in the
press User Guide.
When you press the Tools button in Administrator mode, the following features are
available for selection:
• Full Width Array (FWA) Density Uniformity Adjustment - This procedure is used
to correct and adjust density nonuniformity on prints
• Clean Fuser Assembly - If needed, run this image quality procedure to clean and
remove dry ink/toner debris that may appear on the back side of prints
• DFA Finisher Profile - If the press includes 3rd party DFA inline finishing devices, this
feature is enabled to create a profile of the finisher and add/edit/delete its attributes
• Tools - Select the Tools icon on the screen to access other areas where you can set
system function and security settings:
- System Settings (Common Service Settings and Connectivity/Network Setup)
- Setup (for Billing Impression mode)
- Accounting (Local and Standard Accounting with Auditron is supported)
- Authentication / Security Settings
Note
Use the up/down scroll buttons on the screens to view the entire list of options.
2-1Xerox
®
Versant™ 2100 Press
System Administration Guide
To Next Page
Loading...
