Audio Tones
Use the Audio Tones feature to select whether or not to sound an alarm for various
press functions; for example an alarm can be set to sound when a job ends or there is
a fault. Options include:
Control Panel Select Tone
Select the volume level that sounds when a button on the press Control Panel is correctly
selected. Select from Loud, Normal, and Soft. To disable the sound, select Off.
Control Panel Alert Tone
Select the volume level that sounds when a non-functioning (or grayed-out) button is
selected or when an error occurs. Select from Loud, Normal, and Soft. To disable the
sounds, select Off.
Base Tone
For a button that toggles (the setting changes each time it is pressed), select the volume
level that sounds when the button is in its initial (first) position. Select from Loud,
Normal, and Soft. To disable the sound, select Off.
Machine Ready Tone
Set the volume level that sounds when the press is ready to print or after the press
powers on. Select from Loud, Normal, and Soft. To disable the sound, select Off.
Job Complete Tone
Select the volume level that sounds when the press successfully completes the specific
cycle, such as a print job. Select from Loud, Normal, and Soft. To disable the sound,
select Off. The default setting is Soft.
Fault Tone
Select the volume level that sounds when there is an error termination. Select from
Loud, Normal, and Soft. To disable the sound, select Off.
Auto Clear Alert Tone
Select the volume level that sounds when the automatic clear feature is enabled. Select
from Loud, Normal, and Soft. To disable the sound, select Off.
Alert Tone
Select the volume level that sounds when a fault, such as a paper jam occurs, and the
fault is left unattended. Select from Loud, Normal, and Soft. To disable the sound,
select Off.
6-9Xerox
®
Versant™ 2100 Press
System Administration Guide
Common Service Settings
To Next Page
Loading...
Need help?
General
