Date and Time
Use Date to set the month, day and year of the press clock. The date set here prints on
lists and reports and can be in the format:
• Year/Month/Day
• Month/Day/Year
• Day/Month/Year
Use Time to set the time of the press clock. The time set here prints on lists and reports.
Select either a 12-hour or 24-hour representation.
To set up the date and time on the press:
1. Select Machine Clock/Timers.
2. Select Date and select Change Settings. Enter the Date Format and then the day,
month and year.
3. Select Save.
4. Select Time and select Change Settings. Select either 12 Hour Clock or 24 Hour
Clock. Then select the hours and select Save.
5. Select Close and, if needed, log off the Administrator mode.
NTP Time Synchronization
Set the press to synch with the network time protocol (NTP) server on the network. When
you enable this feature (on), the press time will be in synch and show the same time as
the time on the NTP server. When you change the time, any devices on the network will
also be updated.
1. Select Machine Clock/Timers.
2. From the Machine Clock/Timers screen, select NTP Time Synchronization, and select
Change Settings.
3. Select On to synchronize the times, or Off.
4. Select Save to save the setting and return to the previous window.
5. Select Close and, if needed, log off the Administrator mode.
Connection Interval
Select the time interval at which a connection is made to the time server.
Select an interval from 1 through 500 hours, in steps of one hour.
1. Select Machine Clock/Timers.
2. From the Machine Clock/Timers screen, select Connection Interval, and select Change
Settings.
3. Enter the Connection Interval using the numeric keypad.
4. Select Save to save the settings and return to the previous window.
5. Select Close and, if needed, log off the Administrator mode.
Xerox
®
Versant™ 2100 Press6-4
System Administration Guide
Common Service Settings
To Next Page
Loading...
