To ol s
WorkCentre 5019/5021
User Guide
8-5
System settings
Program
number
Menu item Description
Value
(* default setting)
100 Low Power
Mode Timer
Set the amount of time the machine waits
before entering Low Power mode.
You can set a value between 1 to 60 minutes
(in 1 minute increments).
The machine's power is not turned off
completely in Low Power mode. Instead, this
mode creates a balance between low power
consumption and short warm-up time by
controlling the temperature of the fusing
unit to a level midway between the power
off temperature and the "Ready”
temperature.
1* - 60 minutes
101 Sleep Mode
Timer
Set the amount of time the machine waits
before entering Sleep mode from Low Power
mode.
You can set a value between 1 and 239
minutes (in 1 minute increments).
Sleep mode minimizes power consumption
by shutting off power to all components
except the controller. Warm-up time in Sleep
mode is longer than in Low Power mode.
1* - 239 minutes
102 Auto Reset
Timer
Set the amount of time the machine waits
before automatically returning to the
default display screen when no operation is
being performed.
0: 15 seconds
1: 30 seconds
2: 45 seconds*
3: 1 minute
4: 2 minutes
5: 3 minutes
6: 4 minutes
103 Auto Print
Timer
Set the amount of time the machine waits
after operations such as using the control
panel, placing or removing a document in
the document feeder, and taking out or
putting in a tray, until starting to print
automatically.
You can set a value between 1 and 240
seconds (in 1 second increments).
1 - 240 seconds
(Default: 10 seconds)
104 Auto Scan
Complete Timer
Set the amount of time the machine waits
before automatically processing the next job
when there are no additional documents to
be loaded when using the document glass.
1: 20 seconds
2: 30 seconds*
3: 60 seconds
4: 90 seconds
To Next Page
Loading...
Need help?
General
