Appendix
WorkCentre 5019/5021
User Guide
12-8
Document feeder
The machine does not detect a document placed in the document feeder during Sleep mode.
Notes and restrictions on the use of the copy feature
Copy feature
The machine does not offer the Improves Fit function.
ID Card Copy
The front and back side of the placed ID card are printed on each half sheet of a paper in center except
the following cases:
• When the size of the ID card is larger than the standard printable size of the ID Card Copy feature,
the image is not printed in center.
• When the size of ID card is larger than the standard printable size of the ID Card Copy feature, a
part of the image may be cut off.
• The edges of the ID card may be cut off due to the edge erase.
About memory
If the machine’s memory capacity becomes insufficient when copying using the collate feature, it
outputs only the document data which is being scanned.
Notes and restrictions on the use of the Print feature
Output of long feed documents
The output of long feed documents is not supported.
Print jobs while the control panel is being operated
The print job processing or output speed may be reduced when the control panel is operated during
print job execution.
When the print results differ from the settings
As in the following cases, insufficient memory for the print page buffer may cause print result in not
printing as specified.
• A 2-sided print job is printed on one side.
• A job was terminated (If data cannot be written to the print page buffer, the job including that
page is terminated).
Job counter counts for 2-sided printing
When printing a 2 Sided print job, depending on the application being used, blank sheets can be
inserted automatically to adjust pages. These blank sheets inserted by the application also are counted
by the job counter.
To Next Page
Loading...
Need help?
General
