WorkCentre 5019/5021
User Guide
8-1
8
To ol s
Each machine feature is set to factory default (initial) settings, but you can customize these settings to
match your operating environment. You can change these settings in System Administration mode.
Note Some settings cannot be displayed on certain models. An optional component is required.
For more information, contact our Customer Support Center.
This chapter describes the functions you can change settings for and provides the settings procedures.
System settings procedure
This section gives an overview of how to change the machine's default settings and check machine
information.
Notes
• If there are any current or pending jobs you cannot enter System Administration mode.
• While in System Administration mode you cannot receive a print job or start a print or
scan job.
To Next Page
Loading...
