Operator Cab
Rear View Mirrors
•
DO
NOT
adjust
the seat
or
seat belt
~
while
the
vehicle is moving. Keep
both hands on the wheel
while
the
vehicle is
moving
to
prevent
loss
of
vehicle
control
which
could
result in
injury
or
death.
Three
(3)
adjustable rear view mirrors are provided
to
aid
the operator's rear vision. Two (2) rectangular
mirrors are mounted
on
the upper left
and
right of the
operator's
cab.
One
(1)
rear view mirror is mounted
on
the frame.
Figure
6-15.
Adjust Rear View Mirrors On Cab.
Figure
6-16.
Adjust Rear View Mirror On Frame.
2
Optional
Safety
Belt
3
Inch
Width
Standard
Safety
Belt
2 Inch
Width
Before starting the engine. adjust the seat for posi-
tion and comfort (refer to the Operator Seat section
of this manual) and then adjust the seat belt
as
fol-
lows:
1.
Grasp the free end of the seat belt (located
on
the
left side of the seat) and make sure the belt web-
bing
is
not twisted or entangled
in
any portion of
the seat assembly.
2.
Pull the retractable seat belt across your lap.
Position the seat belt
as
Iowan your body
as
pos-
sible.
3.
Insert the latch plate into the buckle
(on
the right
side of the seat) until a "click"
is
heard.
4.
Make sure seat belt retracts snugly across your
lap.
NOTE: Depress the
red
push button
on
the buckle
to
release the two inch (2") seat belt. Pull the clasp
on
the buckle
to
release the three inch
(3")
seat belt.
Figure
6-14.
Seat Belt.
1.
Push Button Release.
2.
Pull Clasp Release.
Xtreme Manufacturing
31 800-497-1704
To Next Page
Loading...
Need help?
General
