Operation
Starting Vehicle
Normal Starting
•
To
prevent property damage, injury,
or
~
death the operator
must
be seated
with seat
belt
fastened, arms, legs,
and head
completely
inside
the
Rollover Protection Structure/Falling
Object Protection Structure (ROPS/FOPS), the
travel select lever in NEUTRAL,
the
parking
brake
switch
ON
(engaged), and
the
service
brakes applied BEFORE starting
the
vehicle.
1.
Place
key
in
ignition switch.
Figure
7-9.
Key And Ignition Switch.
CAUTION
Release the key immediately once the
motor
starts.
If
the
motor
does
not
start,
DO
NOT crank
the starter
motor
continuously
for
more than 15
seconds. Failure
to
release
the
key after the
motor
has started
or
continuous
cranking can
damage
the
starter motor.
Xtreme Manufacturing
48
2.
Turn
key
in
ignition switch clockwise
to
the
START
position.
OFF RUN
I
/
PREHEAT
I/START"
IXRM-47I
Figure 7-10. Turn Key in Ignition Switch To
START.
3.
Release the key immediately after the engine
starts. The ignition switch will automatically
return
to
RUN.
NOTE: The PREHEAT
and
START
positions are
spring-loaded. When the
key
is
released, the igni-
tion switch will automatically return to the
RUN
posi-
tion.
OFF
RUN"
I
/
PREHEAT
I/START
IXRM-4S!
Figure
7-11.
ignition Switch Automatically Returns To
RUN.
NOTE: Ifthe engine fails to start
on
the first
try,
wait
until the engine
and
starter come
to
a complete stop
before cranking the engine again.
4.
After the engine starts,
run
the engine
at
partial
throttle speed for
30
to 60 seconds.
5.
Return engine to idle speed before engaging the
travel or gear select lever.
6.
Apply the service brake pedal
and
disengage the
parking brake switch.
800-497-1704
To Next Page
Loading...
