3500 Flat Panel Industrial PCs
28
If a touchscreen is factory installed, along with MS-DOS, the mouse port is
unavailable. The unit will arrive with a sticker placed over the port. If you would like
to reconfigure the touchscreen to use the COM2 port, follow the instructions in the
Using a Touchscreen section in this chapter.
Installing Internal Hardware Options
Caution
Turn off the unit before installing internal hardware.
Warning
Installation of expansion boards may void safety and/or EMC compliance.
Remove the lid to install internal hardware options.
DRAM and Additional DRAM Single In-line Memory Modules
(SIMMs)
You can order the 3500 system CPU factory-configured for many configurations of
DRAM. You can reconfigure the DRAM capacity by changing the DRAM SIMMs
on your board. For more information refer to the CPU manual.
PC/AT and PCI Boards
1. Check that the memory and I/O configuration of the board you want to install
does not conflict with the CPU and I/O memory maps in your CPU board
manual.
2. Remove the lid.
3. Remove the ORB screw in the desired track.
4. Slide the PC/AT expansion board into a corresponding rail.
5. Push the board into the backplane connectors.
Note
Do not force the boards or apply uneven pressure.
6. Secure the board by installing the screw through the hole in the board’s metal
ORB and into the top of the track.
7. Replace the lid.
To Next Page
Loading...