Xycom 3510T - Windows  2000 Reinstallation; Installing Drivers; Ethernet Drivers

Chapter Three - Installation
41
Windows

 2000 reinstallation
If you need to reinstall Windows 2000 refer to the Xycom Automation Workstation
Recovery Media Software Installation Instructions for Microsoft
 Windows  2000
(shipped with systems preinstalled with Windows2000). This document is devoted
to the reinstallation of your Windows2000 Workstation operating system and
drivers utilizing the Recovery Media provided with your Xycom Automation
industrial computer.
NOTE: This procedure assumes that the computer hard disk drive has been completely
corrupted or replaced.
WARNING: This procedure will destroy data that may exist on the hard disk drive.
Installing Drivers
This section describes how to install the drivers associated with the system.
Ethernet Drivers
If Windows 95 or Windows NT 4.0 is pre-installed on your system and you
ordered the Ethernet card option, Ethernet drivers are installed on your hard drive in
the C:\netdrv directory.
Note
If you want to use Ethernet capabilities with Windows 95, your system must have
BIOS revision level 1.1 or higher. If the AHIP4+ board is installed, your system must
have BIOS revision level 1.7 or higher.
If MS-DOS is installed on your system, the Ethernet drivers are supplied on your
hard drive in the C:\netdrv directory, but they are not installed.
To install the MS-DOS Ethernet drivers,
1. At the C: prompt, type “cd netdrv”.
2. Once the C:\netdrv path is specified, type “install”.
3. Follow the on-screen instructions to complete installation.
Note
If you install Windows NT 4.0 or Windows 95 on your system, the Ethernet drivers
that are provided do not work with the Ethernet controller installed. You must use the
drivers provided by Xycom Automation. These drivers can be found on the Ethernet
Drivers disk that ships with your system.
Consult the Info directory on the drivers disk for additional installation information.