EasyManuals Logo

Yanmar 6LY3 series Service Manual

Yanmar 6LY3 series
390 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
PERIODIC MAINTENANCE
Periodic Maintenance Procedures
4-12 6LY3 Service Manual
© 2007 Yanmar Marine International
Checking the Electrolyte Level
• Check the level of fluid in the battery
(Figure 4-8, (2)). When the amount of fluid nears
the lower limit (Figure 4-8, (1)), fill with battery
fluid (commercially available) to the upper limit
(Figure 4-8, (3)). If operation continues with
insufficient battery fluid, the battery life is
shortened and the battery may overheat and
explode.
• Battery fluid tends to evaporate more quickly in
the summer, and the fluid level should be
checked more often.
• If the engine cranking speed is so slow that the
engine does not start, recharge the battery.
• If the engine still will not start after charging,
replace the battery.
• When parking, remove the battery and store in a
warm place if the vessel will be left in ambient
temperatures below -15°C (5°F).
Figure 4-8
Figure 4-8
1 – Lower Limit
2 – Electrolyte Level
3 – Upper Limit
4 – Grease
Testing Battery Charge
• Use a battery tester (Figure 4-9, (1)) or
hydrometer to check battery condition. If the
battery is discharged, recharge it.
• Measuring Battery Charge With Battery Tester
Figure 4-9
Figure 4-9
1 – Battery Tester
Measurement with a Battery Tester
When checking the battery with the battery tester,
connect the red clip of the tester to the positive (+)
battery terminal and black clip to the negative (-)
battery terminal. Read the battery charge indicator.
Green zone: Normal
Yellow zone: Slightly discharged
Red zone: Defective or completely discharged
Measuring Battery Charge with a Hydrometer
When using a hydrometer, the measured specific
gravity must be corrected according to the
temperature at the time of measurement. The
specific gravity of battery electrolyte is defined
using 20°C (68°F) as the standard. Since the
specific gravity increases or decreases by 0.0007
when the temperature varies by 1°C (1°F), correct
the value according to the equation below.
0006165
(3)
(1)
(2)
(4)
0006166
(1)
S20 = St + 0.007 ( t - 20 )
Electrolyte temperature
at measurement
Specific gravity at measurement
Converted specific gravity at 20 C
001348-01E

Table of Contents

Other manuals for Yanmar 6LY3 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yanmar 6LY3 series and is the answer not in the manual?

Yanmar 6LY3 series Specifications

General IconGeneral
BrandYanmar
Model6LY3 series
CategoryEngine
LanguageEnglish

Related product manuals