Startup Procedure and Test Run
4
4.5 Start-up Procedures
YASKAWA SIEPC71061753C GA500 Technical Manual 131
4.5 Start-up Procedures
This section gives the basic steps necessary to start up the drive.
Use the flowcharts in this section to find the most applicable start-up method for your application.
This section gives information about only the most basic settings.
Note:
Refer to the A1-06 section to use an Application Preset to set up the drive.
◆ Flowchart A: Connect and Run the Motor with Minimal Setting Changes
Flowchart A shows a basic start-up sequence to connect and run a motor with a minimum of setting changes.
Settings can change when the application changes.
Use the drive default parameter settings for basic applications where high precision is not necessary.
To Next Page
Loading...
