YASKAWA GA800 - Page 81

Troubleshooting
2
2.3 List of Fault, Minor Fault, Alarm, and Error Codes
YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting 81
Display (Hex.) Name ALM LED Type Ref.
oPE03 Multi-Function Input Setting Err Flashing Parameter Setting Error 124
oPE05 Run Cmd/Freq Ref Source Sel Err Flashing Parameter Setting Error 125
oPE06 Control Method Selection Error Flashing Parameter Setting Error 126
oPE07 Analog Input Selection Error Flashing Parameter Setting Error 126
oPE08 Parameter Selection Error Flashing Parameter Setting Error 126
oPE09 PID Control Selection Fault Flashing Parameter Setting Error 127
oPE10 V/f Data Setting Error Flashing Parameter Setting Error 127
oPE11 Carrier Frequency Setting Error Flashing Parameter Setting Error 128
oPE13 Pulse Monitor Selection Error Flashing Parameter Setting Error 128
oPE15 Torque Control Setting Error Flashing Parameter Setting Error 128
oPE16 Energy Saving Constants Error Flashing Parameter Setting Error 128
oPE18 Online Tuning Param Setting Err Flashing Parameter Setting Error 128
oPE20 PG-F3 Setting Error Flashing Parameter Setting Error 128
oPE33 Digital Output Selection Error Flashing Parameter Setting Error 129
oPr (001E) Keypad Connection Fault Illuminated Fault 107
oS (0010) Overspeed Flashing Alarm 120
oS (0018) Overspeed Illuminated Fault 107
ov (0002) Overvoltage Flashing Alarm 121
ov (0008) Overvoltage Illuminated Fault 108
ovEr Too Many Parameters Changed - Not an alarm. 121
PASS Modbus Communication Test Flashing Not an alarm. 121
PE1 (0047) PLC Fault 1 Illuminated Fault 109
PE2 (0048) PLC Fault 2 Illuminated Fault 109
PF (0047) Input Phase Loss Flashing Alarm 121
PF (001B) Input Phase Loss Illuminated Fault 109
PGo (0012) Encoder (PG) Feedback Loss Flashing Alarm 122
PGo (001A) Encoder (PG) Feedback Loss Illuminated Fault 109
PGoH (002B) Encoder (PG) Hardware Fault Flashing Alarm 122
PGoH (0038) Encoder (PG) Hardware Fault Illuminated Fault 109
PWEr DWEZ Password Mismatch - Backup Function Runtime Error 135
rdEr Error Reading Data - Backup Function Runtime Error 135
rF (004E) Braking Resistor Fault Illuminated Fault 110
rH (0010) Braking Resistor Overheat Illuminated Fault 110
rr (000F) Dynamic Braking Transistor Fault Illuminated Fault 110
rUn (001B) Motor Switch during Run Flashing Alarm 122
SC (0005) Short Circuit/ IGBT Failure Illuminated Fault 110
SCF (040F) Safety Circuit Fault Illuminated Fault 110
SE (0020) Modbus Test Mode Error Flashing Alarm 122
SEr (003B) Speed Search Retries Exceeded Illuminated Fault 111
STo (003C) Safe Torque OFF - Alarm 122
SToF (003B) Safe Torque OFF Flashing Alarm 122
STPo (0037) Motor Step-Out Detected Illuminated Fault 111
SvE (0026) Zero Servo Fault Illuminated Fault 111