7-9
168542-1CD
168542-1CD
MLX200 Software and
Operations
7 Configuration and Maintenance of MLX200 Control Module
7.2 Maintenance and Configuration Operations
The MLX200 Control Module may need to be rebooted in order to perform
a firmware update or restore operation or if the IP Address of the Control
Module has been updated. The Control Module can be rebooted using the
following procedure. Click on the “Settings” category in the {Maintenance}
screen and select “Reboot MLX200 Control Module” from the list of
operations as shown in Fig.7-12 "Selecting the Reboot Operation".
Fig. 7-12: Selecting the Reboot Operation
Click on the [Execute] button after selecting the “Reboot MLX200 Control
Module” operation and the user will be presented with the Reboot
Confirmation dialog as shown in Fig.7-13 "Reboot Confirmation Dialog".
Fig. 7-13: Reboot Confirmation Dialog
7.2.5 Retrieving Log Files
The MLX200 PLC Interface application running on the MLX200 Control
Module generates log files during its normal course of operation. These
log files contain initialization and configuration information as well as a log
of certain significant events and faults. Retrieving and reviewing the log
files can prove to be useful for trouble shooting alarms or faults and other
connectivity issues. The {Maintenance Operations} screen of the MLX200
Control Module can be used to retrieve the log files using the following
procedure. Click on the “Log Files” category in the {Maintenance} screen
and select one of the operations from the list of operations as shown in
Fig.7-14 "Selecting Log Files Operations".
To Next Page
Loading...
