YASKAWA Varispeed G7 Series

4 -2
Overview of Trial Operation Procedure
Perform trial operation according to the following flowchart.
* This setting is required when using a 400 V Class Inverter for 55 kW or higher.
Fig 4.1 Trial Operation Flowchart
Installation and Mounting
Wiring and Connections
Power ON
Checking the Display Status
Setting the Power Supply Voltage Jumper*
No-load Operation
Application Settings
(Using Advanced Programming Mode)
Optimum Adjustment and Independent User
Constant Settings
Loaded Operation
Check and Recording User
Constants
Setting the Control Method
Basic Settings
Settings for the Control Methods
START
END
Refer to page 4-3.
Refer to page 4-3.
Refer to page 4-4.
Refer to page 4-6.
Refer to page 4-7.
Refer to page 4-27.
Refer to page 4-27.
Refer to page 4-27.
Refer to page 4-28.
Refer to page 4-4.
TOE-S616-60.1.book 2 ページ ２０１７年８月４日 金曜日 午後３時４１分