124
* These input signals can be used from DeviceNet communications only.
There are no corresponding external input terminals.
002CH
Inverter status
Bit 0 Run (1: Run)
1 Zero-speed (1: Zero-speed)
2 Frequency match (1: Match)
3 Minor fault (Alarm indicated.)
4 Frequency detection 1
(1: Output frequency ≤ setting in n095)
5 Frequency detection 1
(1: Output frequency ≥ setting in n095)
6 Inverter ready for operation (1: Ready)
7 Undervoltage detection
(1: Undervoltage being detected.)
8Baseblock
(1: Inverter output baseblock in progress.)
9 Frequency reference mode
1: Not through communications
0: Through communications
A RUN command mode
1: Not through communications
0: Through communications
B Overtorque detection
(1: Overtorque being detected or overtorque error.)
C Reserved.
D Fault restart in progress
E Fault (1: Fault)
F Not used.
Register
Number
Contents
To Next Page
Loading...
