5. Operating the Inverter
51
Input/Output Terminal Status
Note: 1. “1” is also displayed if command input from DeviceNet communica-
tions or the external control terminal is closed.
2. “1” is displayed if command input from DeviceNet communications
is closed. There are no external terminals.
Note: This can only be used from DeviceNet communications. There is no
external output terminal.
1: Terminal S1 is closed.
1: Terminal S2 is closed.
1: Terminal S3 is closed. (see note 1.)
1: Terminal S4 is closed. (see note 1.)
1: Terminal S5 is closed. (see note 2.)
1: Terminal S6 is closed. (see note 2.)
1: Terminal S7 is closed. (see note 2.)
Input terminal status
1: Terminal MA is closed. (see note.)
1: Terminal P1-PC is closed.
1: Terminal P2-PC is closed.
Output terminal status
To Next Page
Loading...
