Yealink SIP-T48G User Manual

User Guide for the SIP-T48G IP Phone
164
To perform a blind transfer to exist call:
1. Press or tap the Transfer soft key during a call.
2. Tap the desired hold call you want to transfer the call to on the left side.
The call is then connected to the call to which you are transferring.
Semi-attended Transfer
Before performing a semi-attended transfer (except you use dial number method), make sure
that the transfer mode on DSS key is configured as New Call or Attended Transfer. For more
information on how to configure it, refer to Configuring Transfer Mode on DSS Key on page
188.
To perform a semi-attended transfer:
1. Press or tap the Transfer soft key during a call.
2. Do one of the following:
- Enter the number you want to transfer the call to.
Press or to dial out.
- Tap the Directory soft key, and then tap All Contacts. Search for the contact and tap
the desired contact to dial out.
- Tap the Directory soft key, and then tap Remote Phone Book. Search for the contact
and tap the desired contact to dial out. (Remote phone book should be configured in
advance. Refer to Remote Phone Book on page 90 for more information.)
- Tap the History soft key, and then tap the desired list. Tap the desired entry to dial
out.
3. Press or tap Transfer to complete the transfer when receiving ringback.
If you are using a handset, the transfer can be completed by hanging up the handset.

Yealink SIP-T48G Specifications

General

Expansion module support	Yes
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Volume control	-
Display diagonal	7 \
Display resolution	800 x 480 pixels
Lines quantity	- lines
Phonebook capacity	1000 entries
Number of VoIP accounts	6
AC adapter input voltage	100 - 240 V
Number of handles included	1 pc(s)

Weight and Dimensions

Width	266 mm
Height	185 mm