Yealink SIP-T48G

Customizing Your Phone
51
The default value is 10, you can set to 1-30.
5. Click Confirm to accept the change.
Backlight
Backlight has three options:
Active Level: The intensity of the touch screen when the phone is active. You can change the
intensity of the touch screen. Digits (1-10) represent different intensities. 10 is the highest
intensity.
Inactive Level: The intensity of the touch screen when the phone is inactive. You can select a
low intensity or turn off the backlight.
Backlight Time: The delay time to change the intensity of the touch screen when the phone is
inactive. You can select a desired time to change the intensity or turn on the backlight
permanently.
 Always On: Backlight is on permanently.
 15s, 30s, 1min, 2min, 5min, 10min or 30min: Backlight is changed when the phone is
inactive after the designated time (in seconds).
You can also change the intensity of the LCD screen of EXP40 connected to the SIP-T48G IP
phone.
To configure the backlight via phone user interface:
1. Tap ->Basic->Display->Backlight.
2. Tap the gray box of the Active Level field, and then select the desired level from the
pull-down list.
3. Tap the gray box of the Inactive Level field, and then select the desired value from the