Yealink SIP-T48G User Manual

Advanced Phone Features
207
Intercom Barge
You can enable or disable the phone to automatically answer an incoming intercom call while
there is already an active call on the phone. If Intercom Barge is enabled, the phone will
automatically answer the intercom call and place the active call on hold. If Intercom Barge is
disabled, the phone will handle an incoming intercom call like a waiting call. Intercom Barge is
disabled by default.
Note
To configure intercom features via phone user interface:
1. Tap ->Features->Intercom.
2. Make the desired changes.
3. Tap the Save soft key to accept the change or to cancel.
Intercom features are configurable via web user interface at the path Features->Intercom.
Using Intercom
You can use the intercom key in the following ways:
 Place a call to the target extension
 Pick up an incoming call of the target extension
Note
To enable the phone to receive a new incoming call when it has an active call, make sure that call
waiting feature is enabled on the phone in advance. For more information, refer to Call Waiting
on page 165.
To use the intercom key to pick up an incoming call, make sure the intercom subscription feature
is enabled. For more information, contact your system administrator.

Yealink SIP-T48G Specifications

General

Expansion module support	Yes
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Volume control	-
Display diagonal	7 \
Display resolution	800 x 480 pixels
Lines quantity	- lines
Phonebook capacity	1000 entries
Number of VoIP accounts	6
AC adapter input voltage	100 - 240 V
Number of handles included	1 pc(s)

Weight and Dimensions

Width	266 mm
Height	185 mm