Yealink SIP-T48G User Manual

User Guide for the SIP-T48G IP Phone
208
Placing an Intercom Call to the Target Extension
To place an intercom call when the target phone is idle:
1. Tap the intercom key.
The target extension plays a warning tone and automatically answers the call in the
hands-free (speakerphone) mode by default.
2. To end the intercom call, tap the intercom key again or the End Call soft key.
Picking up an Incoming Call of the Target Extension
When the target extension receives an incoming call, the intercom key icon of the target
extension will change to . If you configure the directed call pickup code in advance, you can
pick up the target extension’s incoming call by tapping the intercom key. You can configure the
directed call pickup code when configuring an intercom key. For more information, refer to
Configuring an Intercom Key on page 205.
To pick up an incoming call when the target phone is ringing:
1. Tap the intercom key.
The incoming call of the target extension is answered on the IP phone.
Note
Multicast Paging
You can use multicast paging to quickly and easily broadcast time sensitive announcements to
users who are listening to a specific multicast group and a specific channel. You can configure a
multicast paging key or the paging list key on the phone, which allows you to send a Real Time
Transport Protocol (RTP) stream to the pre-configured multicast address(es) and channel(s)
without involving SIP signaling. You can configure the phone to receive an RTP stream from
pre-configured multicast listening address(es) and channel(s) without involving SIP signaling.
You can specify up to 31 multicast listening addresses and channels.
The following describes 31 paging channels:
 0: You can broadcast audio to channel 0. Note that the Yealink IP phones running old
firmware version (old paging mechanism) can be regarded as listening to channel 0. It is
the default channel.
 1 to 25: You can broadcast audio to a specific channel. We recommend that you specify
these channels when broadcasting with Polycom IP phones which have 25 channels you
can listen to.
 26 to 30: You can broadcast audio to a specific channel. We recommend that you specify
these channels when broadcasting with Yealink IP phones running new firmware version
If the directed call pickup code is not configured, the phone will place a call to the target
extension instead of picking up an incoming call of the target extension when you tap the
intercom key.

Yealink SIP-T48G Specifications

General

Expansion module support	Yes
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Volume control	-
Display diagonal	7 \
Display resolution	800 x 480 pixels
Lines quantity	- lines
Phonebook capacity	1000 entries
Number of VoIP accounts	6
AC adapter input voltage	100 - 240 V
Number of handles included	1 pc(s)

Weight and Dimensions

Width	266 mm
Height	185 mm