Yealink SIP-T48G User Manual

Advanced Phone Features
189
Transferring a Call to the Monitored User
When there is already an active call on the IP phone, you can transfer the active call to the
monitored user by tapping the BLF key. The phone handles the active call differently depending
on the configuration of transfer mode via DSS key with the BLF key (refer to Configuring
Transfer Mode on DSS Key). The transfer mode on DSS key has the following modes:
 Blind Transfer
 Attended Transfer
 New Call
When the transfer mode on DSS key is set to Blind Transfer and there is already an active call
on the IP phone, you can do the following:
To perform a blind transfer:
1. Tap the BLF key of the monitored user which you want to transfer this call to.
Then the active call is connected to the number of the monitored user.
When the transfer mode on DSS key is set to Attended Transfer and there is already an active
call on the IP phone, you can do the following:
To perform a semi-attended transfer:
1. Tap the BLF key of the monitored user which you want to transfer this call to. The phone
will dial the number of the monitored user.
2. Tap the BLF key of the monitored user again or the Transfer soft key to complete the
transfer when receiving ringback.
To perform an attended transfer:
1. Tap the BLF key of the monitored user which you want to transfer this call to. The phone
will dial the number of the monitored user.
2. Tap the BLF key of the monitored user again or the Transfer soft key to complete the
transfer after the monitored user answers the call.
When the transfer mode on DSS key is set to New Call and there is already an active call on the
IP phone, you can do the following:
To perform a new call:
1. Tap the BLF key of the monitored user you want to call.
The phone will dial the number of the monitored user. The original call is placed on hold.
Picking up an Incoming Call of the Monitored User
When the monitored user receives an incoming call, the BLF key icon indicator of the monitored
user will become and flashing. You can use the BLF key to pick up an incoming call of the
monitored user. You can use the BLF key to pick up an incoming call of the monitored user. If
you enable visual alert feature on the phone, you can pick up the incoming call using the

Yealink SIP-T48G Specifications

General

Expansion module support	Yes
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Volume control	-
Display diagonal	7 \
Display resolution	800 x 480 pixels
Lines quantity	- lines
Phonebook capacity	1000 entries
Number of VoIP accounts	6
AC adapter input voltage	100 - 240 V
Number of handles included	1 pc(s)

Weight and Dimensions

Width	266 mm
Height	185 mm