Yealink SIP-T48G User Manual

Getting Started
25
To configure the IP mode via phone user interface:
1. Tap ->Advanced (default password: admin) ->Network->WAN Port.
2. Tap the gray box of the IP Mode field, and then select the desired value (IPv4, IPv6 or IPv4
& IPv6) from the pull-down list.
3. Tap the Save soft key to accept the change or to cancel.
You can configure a static IPv4 address for the IP phone. Before configuring it, make sure that
the IP mode is configured as IPv4 or IPv4 & IPv6.
To configure a static IPv4 address via phone user interface:
1. Tap ->Advanced (default password: admin) ->Network->WAN Port->IPv4.
2. Tap the gray box of the Type field, and then select Static IP from the pull-down list.
3. Enter the desired value in the IP Address, Subnet Mask, Default Gateway, Pri.DNS and
Sec.DNS field respectively.
4. Tap the Save soft key to accept the change or to cancel.
You can configure a static IPv6 address for the IP phone. Before configuring it, make sure that
the IP mode is configured as IPv6 or IPv4 & IPv6.

Yealink SIP-T48G Specifications

General

Expansion module support	Yes
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Volume control	-
Display diagonal	7 \
Display resolution	800 x 480 pixels
Lines quantity	- lines
Phonebook capacity	1000 entries
Number of VoIP accounts	6
AC adapter input voltage	100 - 240 V
Number of handles included	1 pc(s)

Weight and Dimensions

Width	266 mm
Height	185 mm