Yealink T27G

Phone Customization
173
specific line (line 1).
If the “ features.call_park.line_restriction.enable ” is set to 0 (Disabled), the IP phone will park/retrieve the
call to the server on the current line in use.
Note
In Transfer call park mode, if you press the Park key when the phone is idle, the Park key will invoke the call
park code. Therefore, you can use a Park key to park and retrieve a call . In this case, you need to assign the
park retrieve code (*11) to “ features.call_park.park_code ”. When you press the Park key again on idle
screen, the IP phone will dial out “*11*01” to retrieve the parked call.
Example: Setting a Line Key as Directed Pickup key
Scenario Conditions
Related Topic
account.1.direct_pickup_code = *97
or
features.pickup.direct_pickup_code = *97
Directed Call Pickup
Example
linekey.1.type = 9
linekey.1.line = 1
linekey.1.value= 4603
linekey.1.label=Bill
After provisioning, you can easily press the Directed Pickup key (line key 1) to pick up an incoming call to
a specific phone (4603).
Note
The Directed Pickup key invokes the directed pickup code by default. Therefore, the IP phone dials out
*974603 to pick up a call. If the directed code is not set, you can assign code and extension to
“ linekey.X.value ”, for example, “*974603”.
Example: Setting a Line Key as Group Pickup key
The following example shows configuration for a Group Pickup key.
Example
linekey.1.type = 23
linekey.1.line = 1
linekey.1.value = *98
linekey.1.label = Sell
After provisioning, you can easily press the Group Pickup key (line key 1) to pick up an incoming call to
any phone within a predefined group of phones.
Note