Yealink T27G

Phone Network
13
Example:
static.network.ipv6_primary_dns = 3036:1:1:c3c7:c11c:5447:23a6:256
Note: It works only if “static.network.ip_address_mode" is set to 1 (IPv6) or 2 (IPv4 &
IPv6). In DHCP environment, you also need to make sure
“static.network.ipv6_static_dns_enable" is set to 1 (On).
Permitted
Values
IPv6 Address
Default
Blank
Web UI
Network->Basic->IPv6 Config->Static IP Address->Primary DNS
Phone UI
T54S/T52S/T48S/T48G/T46S/T46G/T29G:
Menu->Advanced (default password: admin)->Network->WAN Port->IPv6->Static
IP->Primary DNS
Or Menu->Advanced (default password: admin)->Network->WAN
Port->IPv6->DHCP->Static DNS(Enabled) ->Primary DNS
T42G/T42S/T41P/T41S/T40P/T40G/T27P/T27G/T23P/T23G/T21(P) E2/T19(P) E2:
Menu->Settings->Advanced Settings (default password: admin)->Network->WAN
Port->IPv6->Static IPv6 Client->Pri.DNS
Or Menu->Settings->Advanced Settings (default password: admin)->Network->WAN
Port->IPv6->DHCP IPv6 Client->Static DNS(Enabled) ->Pri.DNS
Parameter
static.network.ipv6_secondary_dns
[1]
<y0000000000xx>.cfg
Description
It configures the secondary IPv6 DNS server.
Example:
static.network.ipv6_secondary_dns = 2026:1234:1:1:c3c7:c11c:5447:23a6
Note: It works only if “static.network.ip_address_mode" is set to 1 (IPv6) or 2 (IPv4 &
IPv6). In DHCP environment, you also need to make sure
“static.network.ipv6_static_dns_enable" is set to 1 (On).
Permitted
Values
IPv6 Address
Default
Blank
Web UI
Network->Basic->IPv6 Config->Static IP Address->Secondary DNS
Phone UI
T54S/T52S/T48S/T48G/T46S/T46G/T29G:
Menu->Advanced (default password: admin)->Network->WAN Port->IPv6->Static
IP->Secondary DNS
Or Menu->Advanced (default password: admin)->Network->WAN
Port->IPv6->DHCP->Static DNS(Enabled) ->Secondary DNS
T42G/T42S/T41P/T41S/T40P/T40G/T27P/T27G/T23P/T23G/T21(P) E2/T19(P) E2:
Menu->Settings->Advanced Settings (default password: admin)->Network->WAN