EasyManua.ls Logo

Yealink VCM34 - Configuring the Mode of Brightness Priority

Yealink VCM34
281 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
| Configuring Camera Settings | 193
Parameter Description Configuration
Method
Photometry
Configure the value of metering.
Average
Central
Bottom
Top
Default: Average.
Web user interface
Endpoint
CTP20/CTP18
Configuring the Mode of Brightness Priority
Procedure
1. Do one of the following:
On your web user interface, go to Setting > Camera > Exposure.
On your VCS: go to More > Settings > Basic > Camera > Exposure.
On your CTP20/CTP18, tap > Settings > Basic > Camera > Exposure.
2. Select Brightness Priority from the Exposure drop-down menu.
3. Configure and save the following settings:
Parameter Description Configuration Method
Brightness
Configure the value of brightness.
Note: the value is from 0 to 14. For
MeetingEye 400/PVT940/VC880/VC800/
VC500/VC200/VC200-E/PVT980/PVT950,
the default value is 6; for MeetingEye 600/
PVT960, the default value is 9.
Web user interface
Endpoint
CTP20/CTP18
Flicker
Configure the value of camera flicker
frequency.
The supported types are as follows:
50 Hz
60 Hz
The indoor lights powered by a 50Hz or 60Hz
power source may produce a flicker. You can
adjust the camera flicker frequency according
to the power source that the light is powered
by.
Default: 50 Hz.
Web user interface
Endpoint
CTP20/CTP18

Table of Contents

Other manuals for Yealink VCM34

Related product manuals