EasyManua.ls Logo

Yealink VCM34 - Configuring Ipv4 or Ipv6; Configuring IP Addressing Mode

Yealink VCM34
281 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
| Configuring Network Settings | 69
Setting the Wireless Network
Wireless Access Point
Configuring DNS Server
DHCP Options
Configuring LLDP
Configuring VLAN Manually
Configuring DHCP VLAN
802.1x Authentication
Enabling/Disabling the PC Port
Network Speed and Duplex Mode
Restricting Reserved Ports
Quality of Service (QoS)
Configuring MTU
Configuring SNMP
Configuring IPv4 or IPv6
Yealink video conferencing system supports IPv4 addressing mode, IPv6 addressing mode, as well as the
IPv4&IPv6 dual stack-addressing mode.
Note:
Yealink video conferencing systems comply with the DHCPv4 specifications documented in RFC
2131, and the DHCPv6 specifications documented in RFC 3315.
Configuring IP Addressing Mode
Configuring IPv4
Configuring IPv6
Configuring IP Addressing Mode
Procedure
1. Do one of the following:
On your web user interface, go to Network > LAN Configuration > Internet Port > IPv4/IPv6.
On your VCS: go to More > Settings > Network Setting > Wired Network > IP Mode.
For VP59, tap > Settings > Network Setting > Wired Network > IP Mode.
On your CTP20/CTP18, tap > Settings > Network Setting > Host Network > Network > Wired
Network > IP Mode.
2. Configure and save the following settings:
Parameter Description Configuration Method
IP Mode/IPv6/IPv4 Configure the IP address mode.
Note: the default mode is IPv4.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20/CTP18

Table of Contents

Other manuals for Yealink VCM34

Related product manuals