| Configuring Network Settings | 84
Parameter Description Configuration Method
VID(1-4094)
Configure the identification of
the Virtual LAN.
Note: the default value is 1. The
value can be any integer from 1
to 4094.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20/CTP18
Priority
Configure the VLAN priority.
Note: the default value is 0. The
value can be any integer from 0
to 7. The smaller the number is,
the higher the priority is.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20/CTP18
Configuring DHCP VLAN
Your system supports VLAN discovery via DHCP. When the VLAN discovery method is set to DHCP, the
system will examine DHCP option for a valid VLAN ID. The predefined option 132 is used to supply the
VLAN ID (it should be predefined on the DHCP server first) by default. The administrator can customize the
DHCP option used to request the VLAN ID.
Procedure
1. On your web user interface, go to Network > Advanced > VLAN > DHCP VLAN.
2. Configure and save the following settings:
Parameter Description Configuration Method
Active/STUN Active
Enable or disable the DHCP
VLAN discovery feature on the
system.
Note: the default value is On.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
To Next Page
Loading...
