Yealink W52H

User Guide W52P/W52H IP DECT Phone
18
To unlock the keypad:
1. Long press again until the LCD screen prompts the message ―Keypad
Unlocked‖.
The keypad is unlocked and the icon disappears from the idle screen.
Note
You can locate a misplaced handset using the base station to which this handset is
registered.
To locate a handset:
1. Press on the base station.
All handsets registered to this base station will ring simultaneously (Paging) and
display the IP address of the base station on the LCD screen.
This helps you locate your handset easily.
You can press any key on the handset or press again on the base station to
end paging.
If the silent mode is switched on, the handset will not ring when receiving an incoming
call, but you can still see the incoming call information on the LCD screen. You can switch
the silent mode on if you do not want to be disturbed.
To switch the silent mode on:
1. Long press until the LCD screen prompts the message ―All Ring Tones Off‖.
The silent mode is on. The icon appears on the idle screen.
To switch the silent mode off:
1. Long press again until the LCD screen prompts the message ―All Ring Tones
On‖.
The silent mode is off. The icon disappears from the idle screen.
The handset provides a variety of features that can be accessed using the menu. The
following section provides you with some basic guidance of navigating the menu.
If the keypad is locked, only the emergency numbers (911, 112, 110 and 999 by default)
can be dialed out. You must enter the three digits of the emergency number continuously
and quickly.