Yealink W52H

Handset Settings
33
5. Press or to highlight the desired handset, and press the OK soft key.
6. Press or to select Accept from the desired line fields.
7. Press the Save soft key to accept the change.
8. Press the Back soft key to return to the previous interface and select the other
handset.
9. Repeat the step 5-7 to assign incoming lines to other handset.
If a line is assigned to multiple handsets as an incoming line, an incoming call to this
line will cause these handsets to ring simultaneously, but the incoming call can be
answered only by one of them.
You can enable the auto answer feature to automatically answer the incoming calls by
lifting the handset from the charger cradle. The auto answer feature works only if the
handset is placed in the charger cradle.
To configure the auto answer feature:
1. Press to enter the main menu.
2. Select Settings->Telephony->Auto Answer.
3. Press the Change soft key to check or uncheck the Auto Answer checkbox.
Intercom calls are internal calls made between handsets registered to the same base
station. You can enable the auto intercom feature on the handset, the handset will
automatically answer an incoming intercom call. The following three configuration types
of the auto intercom feature are available for selection:
 On (Beep On): The auto intercom feature is on. The handset will answer an
incoming intercom call automatically after a short period of ring time.
 On (Beep Off): The auto intercom feature is on. The handset will answer an
incoming intercom call automatically without ringing any tone.
 Off: The auto intercom feature is off. The handset will not answer an incoming
intercom call automatically.
To configure the auto intercom feature:
1. Press to enter the main menu.
2. Scroll to Settings->Telephony->Auto Intercom.
The LCD screen displays three configuration types for selection.
3. Press or to highlight the desired configuration type, and press the
Change soft key.