Yealink W52H

Handset Settings
23
3. Press or to highlight the desired line, the Intercom Call option or the IP
Call option.
4. Press or to select and listen to the ring tone.
5. Press the Save soft key to accept the change or the Back soft key to cancel.
You can also enter the menu Settings->Audio->Ring Tones->Volume, press or to
decrease/increase the ringer volume.
Advisory tones are acoustic signals of your handset, which indicate specific actions and
states. The following advisory tones can be configured independently:
 Keypad Tone: when pressing any key of the keypad.
 Confirmation: when saving settings or placing the handset in the charger cradle.
 Low Battery: when the capacity of the batteries is low.
To configure the advisory tones:
1. Press to enter the main menu.
2. Select Settings ->Audio->Advisory Tones.
3. Press or to select the desired value from the Keypad Tone field.
4. Press or to select the desired value from the Confirmation field.
5. Press or to select the desired value from the Low Battery field.
6. Press the Save soft key to accept the change or the Back soft key to cancel.
The handset backlight status in the charging state or out of the charging state can be
configured respectively. If enabled, the backlight is always on. If disabled, the backlight
is turned off after the handset is idle for a period of time. But the backlight is
automatically turned on when an incoming call arrives, a key is pressed or the status of
the phone changes. You can disable the backlight to save power.
To configure the backlight:
1. Press to enter the main menu.
2. Select Settings->Display->Display Backlight.
3. Press or to select the desired value from the In Charger field.
4. Press or to select the desired value from the Out Of Charger field.
5. Press the Save soft key to accept the change or the Back soft key to cancel.