Yealink W52H

User Guide W52P/W52H IP DECT Phone
42
To place a call on hold:
1. Press the Options soft key during a call, and select Hold.
The call is placed on hold and the icon displays on the LCD screen.
To resume a hold call:
Do one of the following:
- Press the Resume soft key.
- Press .
- Press .
Two Calls on Hold:
If two calls are placed on hold on the handset, press the Resume soft key to resume the
current call. Press , or the Swap soft key to swap between the two calls.
Note
You can enable or disable the call waiting feature on the handset. If the call waiting
feature is enabled, the handset will notify you of a new incoming call during a call, and
present the incoming call information visually on the LCD screen. You can also enable
the handset to play a warning tone when receiving a new incoming call during a call. If
the call waiting feature is disabled, the new incoming call will be automatically rejected
by the handset with a busy tone.
To configure the call waiting feature:
1. Press to enter the main menu.
2. Select Call Features->Call Waiting.
3. Press or to select the desired value from the Status field.
4. Press or to select the desired value from the Tone field.
5. Press the Save soft key to accept the change or the Back soft key to cancel.
Note
To answer a new incoming call during a call:
If call waiting feature is enabled, a new incoming call can be answered during a call.
1. Press the Accept soft key to answer the new incoming call.
When the call on the handset is on hold, placing the handset in the charger cradle will
not end the call.
The call waiting tone works only if the call waiting feature is enabled.