MyPBX U100/U200 Administrator Guide
48/195
2) Voicemail
·Enable Voicemail
Check this box if the user should have a voicemail account.
·Voicemail Access PIN #
Voicemail Password for this extension, e.g. “1234”.
3) Mail Setting
·Enable Send Voicemail
Once enabled, the voicemail will be sent to the below email address as an
attachment.
·Send Voicemail to Email Address
This option defines whether or not voicemails/Fax is sent to the Email address
as an attachment.
Note: Please ensure that all voicemail settings are properly configured on the
System Settings -> Voicemail Settings page before using this feature.
4) Flash
·Hook Flash Detection
Sets the amount of time, in milliseconds, that must pass since the last
hook-flash event received by MyPBX before it will recognize a second event. If a
second event occurs in less time than defined by Hook Flash Detection, then
MyPBX will ignore the event. The default value of Flash is 1000 ms, and it can be
configured in 1ms increments.
5) Group
·Pickup Group
If this extension belongs to a pickup group, any calls that ring this extension can
be picked up by other extensions in the same pickup group by dialing the Call
Pickup feature code (the default is *4).
Note: *4 is the default setting, it can be changed under Feature Codes ->
General -> Call Pickup.
6) Call Duration Setting
Set the max call duration for this extension. This setting is effective when this
extension makes calls. For example, if max call duration of extension 601 is
300s, when 601 makes calls, the call will be disconnected by MyPBX after 300s.
If max call duration is set to 0 or empty, it will follow global max call duration
setting in “SIP Settings”.
Note: This setting will not be valid for internal calls.
To Next Page
Loading...
Need help?
General
