MyPBX U100/U200 Administrator Guide
50/195
This function sets inbound call forwarding on an extension. An administrator can
configure Follow Me for this extension.
9) Volume Settings
Rxgain: The Volume sent to FXS extension.
Txgain: The Volume sent out by the FXS extension
10) Mobility Extension
MyPBX allows you to use your mobile phone as an extension. If you set your
mobile phone as a mobility extension and then you call MyPBX with this mobility
phone, you will hear a dial tone. MyPBX will recognize your call as a call from an
extension. You can dial the number of other extensions (your caller ID will be
the number of your extension) or dial out via outbound routes just like dialing
from your extension.
Note: If callback is enabled in the inbound route, the mobility extension
function of this inbound route will be disabled.
·Enable Mobility Extension
Enable to feature.
·Mobility Extension Number
When you dial the server with this number, the mobile gets the permission of
the extension. For example: dialing the other extensions, playing the voicemail.
·Ring Simultaneously
When the extension has an incoming call, it rings its mobility extension
simultaneously.
·Outbound Prefix
Fill in a proper prefix of mobile number so that it can match an outbound route
to dial the mobility extension. For example, if you set the prefix to “9”, it will
send “9 + mobility extension number” to the outbound route.
11) Spy Settings
MyPBX allows extension to monitor/barge in other conversation. Once this
feature is enabled, the extension has the ability to monitor/barge in other calls
using the feature codes for each spy mode. Refer to “Feature Codes” section for
more information.
·spy modes
There are 4 spy modes available:
Normal spy: you can only hear the call, but can't talk
Whisper spy: you can hear the call, and can talk with the monitored extension
To Next Page
Loading...
Need help?
General
