MyPBX U100&U200 Administrator's Guide
www.yeastar.com Page 95
Note: if you need use the “live music” from “Audio In” interface, please
choose “external music” here.
·Tone Region
Please select your country or nearest neighboring country to enable the default
dial tone, busy tone, and ring tone for your region.
Note: please reboot the system to take effect.
·HTTP bind port/Web Access Port
Port to use for HTTP sessions; Default: 80
Note: please reboot the system to take it effect.
·FXO Mode
FXO port‟s operation mode .
·Virtual Ring Back Tone
It‟s only for GSM/UMTS /UMTS trunk. Once enabled, when the caller call out
with GSM/UMTS trunks, the caller will only hear the virtual ring back tone
generated by the system before callee answers the call.
·Distinctive Caller ID
When incoming calls are routed from ring group/queue/IVR, the caller ID
displays with the name of ring group/queue/IVR, for example
5503302(ringgroup_default).
Note: To display IVR's name, please press the key instead of the extension
number directly.
·Attended Transfer CallerID
When transferring an incoming call using the attended transfer feature code or
the transfer key of IP phone, the Caller ID of transferee or transferer displayed
on the screen of the callee. The default display is the Caller ID of the initiator.
For example, if extension 500 makes a call to extension 501. After 501 picks up
the call, 501 makes an attended transfer to extension 502. If
selecting “Transferer”, 502 will display the Caller ID as 500; if
selecting “Transferee”, 502 will display the Caller ID as 501.
·Follow Me Prompt
When set “Follow me” to “Transfer to number” on the extension page (e.g. when
500 is busy, transfer to 501), while 500 is busy, the call will be transferred to
501. If “Enable Follow Me Prompt” choosing yes, there will be prompt before
transferring the call. Otherwise, the call will be transferred directly without any
prompt. Default: Yes.
To Next Page
Loading...
Need help?
General
