MyPBX U100 & U200 Installation Guide
http://www.yeastar.com 16/16
4.7 Reset to Factory Defaults
If you forget the new IP address or the password of admin, or in other cases that you would like to restore
the factory defaults, please reset the device following the below instructions:
Please press the “RESET” button located in the back panel with a paper clip or a pencil tip, then you can see
all of the LED indicators in the front panel would all turn red first and turn orange seconds later. When the
indicator light becomes orange, the button could be released and system begins to reset. During the process,
please do not power off until the LED indicators become normal which means the reset process is completed.
Note: After resetting, all the configurations made by the admin would be erased.
5. Conclusion
This Installation Guide only explains the installation and basic settings of MyPBX U100 and U200 for making
and receiving calls. For more functionality and advanced settings of MyPBX U100 and U200, please refer to
the relative documents as below:
“MyPBX U100 Datasheet”
“MyPBX U200 Datasheet”
“MyPBX U100 & U200 Administrator’s Guide”
“MyPBX U100 & U200 Extension User's Guide”
[The End]