MyPBX U100&U200 Administrator's Guide
www.yeastar.com Page 119
6.7.9 SMS Settings
When GSM/UMTS modules are installed, SMS feature is supported.
1) Enable SMS to Email
Figure 6-74
If you enable this, as soon as the GSM/UMTS trunks receive small messages,
MyPBX will send the text of this message to the email addresses listed on the
Email List.
You can add email addresses to the Email List
Figure 6-75
2) Enable Email to SMS
If you enable this, you can use MyPBX to send out message by sending an email
to the specified address.
Figure 6-76
·Enable Country Code
If you want to add country code before the dialed numbers, please tick this.