MyPBX U100&U200 Administrator's Guide
www.yeastar.com Page 26
5.3 System Preference
In this page, we can set other system preference, like the password for
admin/user/cdr account, system date and time, firmware update, hot standby,
backup and restore, reset and reboot.
5.3.1 Password Settings
MyPBX has 3 accounts: admin, user, and cdr. User and cdr account is disabled
by default.
Admin account:
The default password for account “admin” is “password”. To change the
password, select “admin” in “User”, enter the old password and new password,
click “Save”. The system will then prompt you to re-login using your new
password.
After you enter the new password, MyPBX will prompt the password strength. It
is recommended that you use numbers, upper-case letters, and lower-case
letters to increase the security.
When you log in MyPBX using “admin” account, you can enable “user” and “cdr”
account; also, you can change their passwords.
Figure 5-12
User account:
User account is disabled by default and its default password is “password”.
When enabling “user” account for the first time, MyPBX will ask you to
change “user” password. If you don‟t change it, you can‟t enable “user” account.
To change the password, select “user” in “User”, enter the old password and
new password, click “Save”. The system will then prompt you to re-login using
your new password.
After you enter the new password, MyPBX will prompt the password strength. It
is recommended that you use numbers, upper-case letters, and lower-case
letters to increase the security.
To Next Page
Loading...
Need help?
General
