MyPBX U100&U200 Administrator's Guide
www.yeastar.com Page 14
5 System
Click to access.
In this page, we can configure the network settings, firewall settings, storage
management and some other preferences like firmware update and hot
standby.
5.1 Network Preferences
5.1.1 LAN Settings
Figure 5-1
·DHCP
If this option is set, MyPBX will use DHCP to get an available IP address from
your local network. Not recommended or you cannot access MyPBX without the
right IP address
·Enable SSH
This is the advance way to access the device, you can use the putty software to
access the device. In the SSH access, you can do more advanced setting and
debug, it‟s disabled by default.
·Port: the default is 8022; you change it to another one