MyPBX U100&U200 Administrator's Guide
www.yeastar.com Page 117
of calls in relation to particular activities or clients. They can also be used to
keep track of calls by particular users or sets of users.
• PIN entered are checked against those stored by the system. If an invalid PIN
is entered, the PIN is requested again.
• The system administrator can configure certain numbers or types of numbers
to require entry of a PIN before you can continue making a call to such a
number.
• The system administrator can also configure you to have to enter a PIN before
making any external call.
·Name
A character-based name for this PIN list, i.e. “YeastarPIN”
·PIN List
Enter a list of one or more PINs, One PIN per line.
·Outbound Route
PIN User can use those outbound route to make call out.
6.7.8 Paging Groups
Paging is used to make an announcement over the speakerphone to a phone or
group of phones. Targeted phones will not ring, but instead answer immediately
into speakerphone mode. Please note that this section is for configuring paging
groups. If you would like to configure Intercom settings, please open the Other
Settings -> Feature Codes screen.
This feature is supported by the following SIP phones:
Yealink's T28, T26, T22, T20, T10T, T9CM. Other SIP devices may also work
with this feature but are not officially supported.
Note: A paging group can have a maximum of 20 members.
Figure 6-71
There are two types of paging groups in MyPBX U100&U200.
1. Internal paging Group
In this mode, if you dial its number, MyPBX will help to pick up those chosen
members and you can talk directly without any rings.
To Next Page
Loading...
Need help?
General
