MyPBX U100&U200 Administrator's Guide
www.yeastar.com Page 103
Allow callers to review their recorded message before sending it to voicemail.
2) SMTP Settings for Voicemail
Note: If you want to send voicemail messages as email attachments, please
configure this section.
Figure 6-54
·E -mail Address
The E-mail Address that MyPBX will use to send voicemail.
·Password
The password for the email address used above
·SMTP Server
The IP address or hostname of an SMTP server that the MyPBX will connect to in
order to send voicemail messages via email, i.e. mail.yourcompany.com.
·Port
SMTP Port: the default value is 25.
·Use SSL/TLS to send secure message to server
If the server of sending email needs to authenticate the sender, you need to
select the check box.
Note: Must be selected for Gmail or exchange server.
After filling out the above information, you can click on the “Test Account
Settings” button to check whether the setup is OK.
1) If the test is successful, you can use the email safely.
2) If test failed, please check if the above information is correct or network is
proper.