EasyManuals Logo

Yeastar Technology MyPBX U100 User Manual

Yeastar Technology MyPBX U100
197 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #125 background imageLoading...
Page #125 background image
MyPBX U100&U200 Administrator's Guide
www.yeastar.com Page 109
traffic. When the network capacity is insufficient, QoS could provide priority
to users by setting the value.
Figure 6-59
5) Advanced Settings
·From Field
Where to get the caller ID in sip packet.
·To Field
Where to get the DID in sip packet.
·180 Ringing
It is set when the telecom provider needs. Usually it is not needed.
·Remote Party ID
Whether send Remote-Party-ID on SIP header. Default no.
·Allow Guest
Whether allow anonymous registration extension. Default: no.
This option is used to avoid some anonymous calls by hackers. For more details
about the system security configuration, please refer to APPENDIX I MyPBX
Security Configuration Guide.
·Pedantic
Enable pedantic parameter. Default: no.
·Alwaysauthreject
If enabled, when MyPBX rejects “Register” or “Invite” packets, MyPBX always
respond the packets using “SIP404 NOT FOUND”.
·Session -timers
Enable session-timer mode, default: yes

Table of Contents

Other manuals for Yeastar Technology MyPBX U100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yeastar Technology MyPBX U100 and is the answer not in the manual?

Yeastar Technology MyPBX U100 Specifications

General IconGeneral
BrandYeastar Technology
ModelMyPBX U100
CategoryTelephone Accessories
LanguageEnglish