MyPBX U100&U200 Administrator's Guide
www.yeastar.com Page 43
setting in “SIP Settings”.
7) Other options
·Call Waiting
Check this option if the extension should have Call Waiting capability. If this
option is checked, the “When busy” follow me options will not be available.
·DND
Don‟t Disturb.
·User Web Interface
Check this option to allow the user to login to the MyPBX User Web interface,
which can be used to access voicemail and extension recordings. Users may
login to the MyPBX User Web interface by using their extension number and
voicemail PIN # as the login and password respectively.
·Ring Out
Check this option if you want to custom the ring time. Tone will stop over the
time defined
8) Follow me (Call Forwarding)
This function sets inbound call forwarding on an extension. An administrator can
configure Follow Me for this extension
9) Volume Settings
Rxgain: The Volume sent to FXS extension.
Txgain: The Volume sent out by the FXS extension
10) Mobility Extension
MyPBX allows you to use your mobile phone as extension. If you set your mobile
phone as mobility extension and then you call MyPBX with this mobility phone,
you will hear a dial tone. MyPBX will recognize your call as a call from an
extension. You can dial the number of other extensions (Your caller ID will be
the number of your extension) or dial out via outbound routes just like dialing
from your extension.
Note: If callback is enabled in the inbound route, the mobility extension
function of this inbound route will be disabled.
11) Spy Settings
MyPBX allows extension to monitor/barge in other conversation. Once this
feature is enabled, the extension has the ability to monitor/barge in other calls
using the feature codes for each spy mode, refer to 'Feature Codes' page for
To Next Page
Loading...
Need help?
General
