App-3
IM 04P01B01-17E
App
Appendix
Example in which the FIFO acquiring interval on the recorder is set to 1 s and the
measured data from channel 01 to 06 are continuously output (logging function)
BINARY header
BINARY data
BINARY footer
FF RESET
YES
NO
END
Send command
Stop measurement?
Receive response
E0
Send command
Receive response
Wait for the FIFO
acquiring interval (1 s)
Move the FIFO read position to the most recent acquire position.
Command description
Command to send
Received response data
Output the measured/computed data using the FIFO.
START
BINARY (see page 5-2 and 5-13)
FF GET,01,06
Note
• The FIFO acquiring interval must be set using the FR command beforehand.
• The FIFO acquiring interval applies to both serial and Ethernet communications.
Appendix 2 Output Flow of FIFO Data
To Next Page
Loading...
Need help?
General
