4-1
IM 04P01B01-17E
4
Commands
4.1 Command Syntax
The syntax of the setting/basic setting/output commands (see sections 4.4 to 4.7) of the
instrument is given below. ASCII codes (see appendix 1) are used for the character codes.
For the Maintenance/Test command syntax, see section 4.9.
For the Instrument Information server command syntax, see section 4.10.
Command name Parameter
?
Terminator
Delimiter
Sub delimiter
SR 02,SKIP;SR 03,VOLT,2V,-1500,1800
Parameter (02 SKIP·····1800)
Delimiter (,)
Command name (SR)
Sub delimiter (;)
Command example
• Command Name
Defined using two alphabet characters.
• Parameter
• Command parameters.
• Set using alphabet characters or numerical values.
• Parameters are separated by delimiters (commas).
• When the parameter is a numerical value, the valid range varies depending on the
command.
• Spaces before and after of the parameter are ignored (except for parameters that
are specified using an ASCII character string (unit, tag, and message string), when
spaces are valid.)
• You can omit the parameters that do not need to be changed from their current
settings. However, delimiters cannot be omitted.
Example SR 01,,2V<terminator>
If multiple parameters are omitted and delimiters occur at the end of the command,
those delimiters can be omitted.
Example SR 01,VOLT,,,<terminator> → SR 01,VOLT<terminator>
• The number of digits of the parameters below is fixed. If the number of digits is not
correct when entering the command, a syntax error results.
• Date YY/MM/DD (8 characters)
YY: Year (Enter the lower two digits of the year.)
MM: Month
DD: Day
• Time HH:MM:SS (8 characters)
HH: Hour
MM: Minute
SS: Second
• Channel number: 2 characters (Example: 01, 0A)
• Relay number: 3 characters (Example: I01)
• Communication input data: 3 characters (Example: C02)
• Constants used in the computation function (/M1 option): 3 characters
(Example: K03)
• Remote control (/R1 option) input terminal status: 3 characters (Example: D04)
Chapter 4 Commands
To Next Page
Loading...
Need help?
General
