YOKOGAWA DLM4038 User Manual

5-94
IM DLM4038-17EN
:CURSor[:TY]:VERTical:V<x>:VALue?
Function Queries the vertical value of a ΔT cursor.
Syntax
:CURSor[:TY]:VERTical:V<x>:VAL
ue? [BUS]
<x> = 1 to 2
Example
:CURSOR:TY:VERTICAL:V1:VALUE?
-> :CURSOR:TY:VERTICAL:V1:VALUE 2.50
E+03
Description • You can specify BUS when
:LOGic:PODL:MODE
is set to ON and the
:CURSor[:TY]:DEGRee:TRACe
is set to 8.
An error will occur if you specify BUS when the
above settings have not been made.
If BUS is not specified, the cursor
values are output according to the
:LOGic:PODL:BITOrder
and
:LOGic:PODL:BIT<x>:DISPlay
settings.
If BUS is specified, the cursor
values are output according to the
:LOGic:PODL:BUS:ASSignment
setting.
•
:CURSor[:TY]:DEGRee:TRACe
is set to
ALL, cursor values are output in the following
order:channel 1 to channel 7, channel 8 or
the logic bus, logic input waveform, computed
waveform 1 to 4.
• If
:LOGic:PODL:BUS:DISPlay
is set to OFF,
the cursor value will be “NAN” (Not A Number).
5.10 CURSor Group

YOKOGAWA DLM4038 Specifications

General

Brand	YOKOGAWA
Model	DLM4038
Category	Test Equipment
Language	English