ix
IM 34M06H62-02E 3rd Edition : Jul.16, 2015-00
Introduction
Overview of the Manual
This instruction manual describes the specifications, functions and use of the
Temperature Control and PID Module. The information is especially useful when you
are performing pre-operation engineering.
ToolBox for Temperature Control and PID Modules
A dedicated ToolBox software is provided for this module. With this software, you can
easily set up various parameters of the module, as well as perform action tests, tuning
and monitoring by following screen instructions. For details, see the “ToolBox for
Temperature Control and Monitoring Modules User’s Manual” (IM34M06Q31-02E).
Notation
References to chapters and sections are denoted by the chapter or section number,
followed by the chapter or section title enclosed within double-quotation marks.
Relay names and register names are shown with Initial caps.
States or setting values are enclosed within double quotation marks, or displayed with
initial caps.
Other User’s Manuals
Read the following manuals, as required.
For information on the specifications, configuration*, installation,
wiring, trial operation, maintenance and inspection of the e-RT3, as well
as information on the system-wide limitation of module installation,
refer to:
- Hardware Manual (IM 34M06C11-01E).
*: For information on the specifications of products other than the power supply module, base module, I/O module, cable
and terminal block unit, refer to their respective user’s manuals.
To Next Page
Loading...
Need help?
General
