YOKOGAWA WT110 User Manual

IM 253401-01E
App2-32
Appendix 2.3 Commands
2.3.14 STORe Group
The commands in the STORe group are used to make settings relating to and inquiries about storing data. This allows you to
make the same settings as when using the lower menus of [MEMORY]-”StorE” or [MEMORY]-”PnLSt”.
:STORe : STAT e <Space> OFF
ON
<NRf>
?
INTer val <Space> <NRf> , <NRf> , <NRf>
?
PANel <Space> <NRf>
?
<Character string>
;
STORe?
Function Queries all settings related to storing data.
Syntax STORe?
Example STORE? → :STORE:STATE 0;INTERVAL 0,0,0
STORe:INTerval
Function Sets the interval for storage/queries the current setting.
Syntax STORe:INTerval {<NRf>,<NRf>,<NRf>|<String>}
STORe:INTerval?
{<NRf>,<NRf>,<NRf>}=0,0,0 to 99,59,59
{<String>}=HH:MM:SS HH hour MM min SS sec
Example STORE:INTERVAL 0,0,0
STORE:INTERVAL “00:00:00“
STORE:INTERVAL?
→ :STORE:INTERVAL 0,0,0
Description • If the storage interval is set to 0,0,0, the storage
interval becomes 250ms in case of normal
measurement.
• For the storage interval in case of harmonic analysis,
refer to page 9-2.
STORe:PANel
Function Saves the set-up parameters to a file.
Syntax STORe:PANel {<NRf>}
{<NRf>}=1 to 4:file number
Example STORE:PANEL 1
STORe[:STATe]
Function Sets store ON/OFF, queries the current setting.
Syntax STORe[:STATe] {<Boolean>}
STORe:STATe?
Example STORE:STATE ON
STORE:STATE? → :STORE:STATE 1

YOKOGAWA WT110 Specifications

General

Brand	YOKOGAWA
Model	WT110
Category	Measuring Instruments
Language	English